See Our team
Wondering how we keep quality?
Got unsolved questions? Ask Questions
Engineering GATE CBSE NCERT Psychology English Computer Constitution Astrology Yoga Economics Physics Biology Electronics Microprocessor Career Interview Anatomy Botany
An electric lamp of 100 Ω, a toaster of resistance 50 Ω, and a water filter of resistance 500 Ω are connected in parallel to a 220 V source. What is the resistance of an electric iron connected to the same source that takes as much current as a1 AnswerAn electric lamp, whose resistance is 20 Ω, and a conductor of 4 Ω resistance are connected to a 6 V battery. Calculate (a) the total resistance of the circuit, (b) the current through the circuit, and (c) the potential difference acr1 AnswerA hot plate of an electric oven connected to a 220 V line has two resistance coils A and B, each of 24 Ω resistance, which may be used separately, in series, or in parallel. What are the currents in the three cases? -CBSE Physics 1 AnswerAn electric iron of resistance 20 Ω takes a current of 5 A. Calculate the heat developed in 30 s. -CBSE Physics 1 AnswerThe differential amplifier is connected as shown in the figure(b) above to a single strain gage bridge. Let the strain gage resistance vary around its no load resistance R by ±1%. GATE-Instrumentational-Engineering-20131 AnswerAn electric iron has a rating of 750 W, 220 V. Calculate -2007 CBSE Physic class 101 AnswerTwo metallic wires A and B of the same material are connected in parallel. Wire A has length l and radius r, wire B has a length 2l and radius 2r. Compute the ratio of the total resistance of parallel combination and the resistance of wire A. -CBSE p1 AnswerA 0-1 Ampere moving iron ammeter has an internal resistance of 50 mΩ and inductance of 0.1 mH. A shunt coil is connected to extend its range to 0-10 Ampere for all operating frequencies. The time constant in milliseconds and resistance in mΩ of the shunt coil respectively are0 Answer Several electric bulbs designed to be used on a 220 V electric supply line, are rated 10 W. How many lamps can be connected in parallel with each other across the two wires of 220 V line if the maximum allowable current is 5 A? -CBSE Physics 1 AnswerJudge the equivalent resistance when the following are connected in parallel – (a) 1 Ω and 106 Ω, (b) 1 Ω and 103 Ω, and 106 Ω. -CBSE Physics 1 AnswerAn electric iron consumes energy at a rate of 840 W when heating is at the maximum rate and 360 W when the heating is at the minimum. The voltage is 220 V. What are the current and the resistance in each case? -CBSE Physics 1 AnswerA 230 V, 50 Hz ac supply is applied to a coil of 0.06 H inductance and 2.5 resistance connected in series with a 6.8 µF capacitor. Calculate (i) Impedance (ii) Current (iii) Phase angle between current and voltage (iv) power factor1 AnswerWhich has a higher resistance : a 50 W lamp bulb or a 25 W lamp bulb and how many times ? -2005 CBSE Physic class 101 AnswerIn a household electric circuit different appliances are connected in parallel to one another. Give two reasons. 2009 CBSE Physic class 101 Answer When a 12 V battery is connected across an unknown resistor, there is a current of 2.5 mA in the circuit. Find the value of the resistance of the resistor. -CBSE Physics 1 AnswerAn electric bulb is rated at 100 W for a 220 V supply. Calculate (a) the resistance of the bulb, and (b) the current flowing through the bulb (Physics CBSE 2018)1 AnswerA long-channel NMOS transistor is biased in the linear region with 𝑉𝐷𝑆=50 mV and is used as a resistance. Which one of the following statements is NOT correct? Gate-20161 Answer Two lamps, one rated 100 W at 220 V, and the other 60 W at 220 V, are connected in parallel to electric mains supply. What current is drawn from the line if the supply voltage is 220 V? -CBSE Physics 1 AnswerTwo lamps, one rated 100 W; 220 V, and the other 60 W; 220 V, are connected in parallel to electric mains supply. Find the current drawn by two bulbs from the line, if the supply voltage is 220 V.1 AnswerR1 = 10 Ω, R2 = 40 Ω, R3 = 30 Ω, R4 = 20 Ω, R5 = 60 Ω, and a 12 V battery is connected to the arrangement. Calculate (a) the total resistance in the circuit, and (b) the total current flowing in the circuit-CBSE Physics 1 Answer
EE2151 CIRCUIT THEORY Integrated Power Electronics ModuleGE6252 Basic Electrical and Electronics Engineering Anna university notesElectronic CircuitsABB PAPER - 02 MAY 2004 - VADODARA Magneto-optical current transformer technologyAce of Fire: The SourceEC2151 ELECTRIC CIRCUITS AND ELECTRON DEVICES Sun in First HouseElectric and Electronic Measurement and Instrumentation - 10EE55 VTU notes
Loading More post