Checkout our YouTube channel for video tutorials and learn more about Eduladder.

New updates

Searching for :Quality control focuses on Date:2022-12-10 06:11:19Done by:Anonymous user(Visitor)Updated ProfileDate:2022-12-10 06:03:15Done by:kolbybbest

Searching for :Nid answer sheet 2010Date:2022-12-10 05:46:48Done by:Anonymous user(Visitor)

View All

Career 2.0

You might be intrested on below oppertunities Show me All

Posted By:Eduladder

### Similar Questions

**A soil has a void ratio of 0.75 and a specific gravity of 2.66. The value of critical hydraulic gradient at which quick sand condition will occur is. GATE- Agricultural Engineering- 2013**

1 Answer

**If the water content of a fully saturated soil mass is 100%, the void ratio of the sample is: - gate civil 2017**

1 Answer

**If the water content of a fully saturated soil mass is 100%, the void ratio of the sample is: - gate civil 2017**

1 Answer

**If the water content of a fully saturated soil mass is 100%, the void ratio of the sample is: -gate civil 2017**

1 Answer

**If the water content of a fully saturated soil mass is 100%, the void ratio of the sample is -gate civil 2017**

1 Answer

**If the water content of a fully saturated soil mass is 100%, the void ratio of the sample is: - gate civil 2017**

1 Answer

1 Answer

**If the water content of a fully saturated soil mass is 100%, the void ratio of the sample is: -gate civil 2017**

1 Answer

**In a soil specimen, the total stress, effective stress, hydraulic gradient and critical hydraulic gradient are , ', i and ic, respectively. For initiation of quicksand condition, which one of the following statements is TRUE?**

0 Answer

**A 588 cm3 volume of moist sand weighs 1010 gm. Its dry weight is 918 gm and specific gravity of solids, G is 2.67. - gate civil 2017**

1 Answer

**I f the void ratio of a soil column is 0.43, the soil porosity is (A) 0.30 (B) 0.40 (C) 0.70 (D) 0.75 (GATE-Agricultural-Engineering-2018)**

1 Answer

**The pressure that does not have any measurable influence on the void ratio or shearing resistance of the soil mass is. GATE- Agricultural Engineering- 2013**

2 Answer

**A soil has bulk density and particle density of 1.48 Mg m^-3 and 2.64 Mg m^-3, respectively. The saturated volumetric moisture content of soil is 36%. The porosity and void ratio of the soil are Gate-Agricultural-2016**

1 Answer

**A coarse sand aquifer has porosity 20% and hydraulic conductivity 3.5x10^-3 m/s. If the hydraulic gradient is 0.00423 (m/m), then the average linear velocity of the groundwater in mm/s, (rounded off to three decimal places) is __________.**

0 Answer

**T he void ratio of a soil is 0.55 at an effective normal stress of 140 kPa. The compression index of the soil is 0.25. In order to reduce the void ratio to 0.4, an increase in the magnitude of effective normal stress (in kPa, up to one decimal place) should be ______ (GATE-CIVIL-Engg-2018)**

1 Answer

**The depths from the soil surface to subsurface tile drains, impermeable soil layer and the highest water table are measured as 2.8 m, 5.0 m and 0.8 m, respectively. The effective hydraulic head for drainage in meter is (GATE-Agricultural-Engineering-2018)**

1 Answer

**A sand water slurry of specific gravity 1.45 contains sand of grain density 2.6 g/cc. The weight percent of sand in the slurry (rounded off to two decimal places) is __________.**

0 Answer

**An earth embankment is to be constructed with compacted cohesionless soil. The volume of the embankment is 5000 m3 and the target dry unit weight is 16.2 kN/m3 . Three nearby sites (see figure below) have been identified from where the required soil can be transported to the construction site. The void ratios (e) of different sites are shown in the figure. Assume the specific gravity of soil to be 2.7 for all three sites. If the cost of transportation per km is twice the cost of excavation per m3 of borrow pits, which site would you choose as the most economic solution? (Use unit weight of water = 10 kN/m3 ) - gate civil 2017**

1 Answer

**I f the total porosity of a soil is 20%, its void ratio (%) is _________.**

1 Answer

**A 10 m wide rectangular channel carries a discharge of 20 m^3/s under critical condition. Using g = 9.81 m/s^2, the specific energy (in m, up to two decimal places) is ______ (GATE-CIVIL-Engg-2018)**

1 Answer

### Notes

**CE2308 SOIL MECHANICS LABORATORY**

**CE2251 SOIL MECHANICS**

**GATE- Agricultural Engineering- 2013**

**GEOTECHNICAL LABORATORY EXPERIMENTS**

**CE2355 ENVIRONMENTAL AND IRRIGATION ENGINEERING DRAWING**

**CE2033 GROUND IMPROVEMENT TECHNIQUES**

**CE2253 APPLIED HYDRAULIC ENGINEERING**

**CE2305 FOUNDATION ENGINEERING**

**CE2301 IRRIGATION ENGINEERING**

**GATE Electronics and Communication Engineering Question Paper 2013 download**

## View question

## A soil has a void ratio of 0.75 and a specific gravity of 2.66. The value of critical hydraulic gradient at which quick sand condition will occur is. GATE- Agricultural Engineering- 2013

(B) 1.05

(C) 2.09

(D) 6.64

Asked On2017-07-03 08:31:42 by:Fututron

Taged users:

Likes:

Be first to like this question

Dislikes:

Be first to dislike this question

## Comments