See Our team
Wondering how we keep quality?
Got unsolved questions? Ask Questions
Engineering GATE CBSE NCERT Psychology English Computer Constitution Astrology Yoga Economics Physics Biology Electronics Microprocessor Career Interview Anatomy Botany
During normalizing process of steel, the specimen is heated -Mechanical Engineering-gate-20121 AnswerA tensile specimen was deformed to a true strain of 0.405. The change in the gauge length was 5 mm. The final gauge length of the specimen, in mm, is: (-Gate metallurgical engineering 2014)1 AnswerThe real root of the equation 5x − 2cosx −1 = 0 (up to two decimal accuracy) is ____. (Gate mechanical engineering 2014)1 AnswerThe contents of a well-insulated tank are heated by a resistor of 23Ω in which 10A current is flowing. -gate-mechanical-20111 AnswerIn a steel plate with bolted connections, the rupture of the net section is a mode of failure under -Civil Engineering-gate-20121 AnswerA diesel engine has a compression ratio of 17 and cut-off take place at 10% of the stroke. Assuming ratio of specific heats ( γ ) as 1.4, the air-standard efficiency (in percent) is______. (Gate mechanical engineering 2014)1 AnswerIf AIV for specimen A is 25 and that for specimen B is 45 Which one is better for surface of a pavement Justify it?1 AnswerExplain the process of combustion of fuel with the help of chemical equations.1 AnswerA 0.2 wt.% plain carbon steel sheet is heated and equilibrated in the inter-critical region followed by instant water quenching. The microstructure of the quenched steel sheet consists of, GATE- Metallurgical Engineering- 2013 1 AnswerA steel rod was subjected to a fluctuating stress cycle that varied between a maximum of 400 MPa in tension to a minimum of 300 MPa in compression. What is the stress amplitude, in MPa?______. (-Gate metallurgical engineering 2014)1 AnswerThe process utilizing mainly thermal energy for removing material is: (Gate mechanical engineering 2014)1 AnswerWhat is soldering? Classify soldering process.1 AnswerGiven the sequence of terms, AD CG FK JP, the next term is -Mechanical Engineering-gate-20121 AnswerWhich one of the following signals from a specimen is used in a scanning electron microscope to get quantitative elemental analysis? (-Gate metallurgical engineering 2014)1 AnswerWhich one of the following options is the closest in meaning to the word given below? -Mechanical Engineering-gate-20121 AnswerIf a mass of moist air in an airtight vessel is heated to a higher temperature, then -gate-mechanical-20111 AnswerThe percent voids in mineral aggreg ate (VMA) and percent air voids (V v ) in a compacted cylindrical bituminous mix specimen are 15 and 4. 5respectively. The percent voids filled with bitumen (VFB) for this specimen is:1 AnswerA sonometer wire of length 1.5 m is made of steel. The tension in it produce an elastic strain of 1%. What is the fundamental frequency of steel if density and elasticity of steel are 7.7 × 103 kg / m3 and 2.2 × 1011 N/m2 respectively ? - physics 20130 AnswerWhich one of the following is NOT a decision taken during the aggregate production planning stage? -Mechanical Engineering-gate-20121 AnswerA single–point cutting tool with 12 degree rake angle is used to machine a steel work– piece. -gate-mechanical-20111 Answer