See Our team
Wondering how we keep quality?
Got unsolved questions? Ask Questions
Engineering GATE CBSE NCERT Psychology English Computer Constitution Astrology Yoga Economics Physics Biology Electronics Microprocessor Career Interview Anatomy Botany
A harmonic oscillator is oscillating with a frequency of 3 Hz. .Physics CBSE class 11 20160 AnswerGate-20161 Answer.Gate-20161 AnswerThe Miller effect in the context of a Common Emitter amplifier explains -gate Electronics and Communication 20171 AnswerA police car with a siren of frequency 8 kHz is moving with uniform velocity 36 km/hr towards a tall building which reflects the sound waves. The speed of sound in air is 320 m/s. The frequency of the siren heard by the car driver is - jee main 2012 physics 1 AnswerThe amplitude of a damped oscillator decreases to 0.9 times its original magnitude in 5s. In another 10s it will decrease to α times its original magnitude, where α equals : - physics 20131 AnswerA pendulum oscillates 40 times in 4 seconds. Find its time period and frequency. cbse-class8-physics-20151 AnswerVoice of which of the following is likely to have minimum frequency? cbse-class8-physics-20151 AnswerThe maximum frequency of a force signal in Hz below the natural frequency within its useful midband range of measurement, for which the gain amplitude is less than 1.05 approximately is: GATE-Instrumentational-Engineering-20131 Answer In frequency domain IP, which one of the following frequency ranges (in Hz) is used to measure apparent resistivity at DC and AC limits? -gate Geology & Geophysics 20172 AnswerA band limited signal with a maximum frequency of 5 kHz is to be sampled.According to the sampling theorem, the sampling frequency in kHz which is not valid is GATE-Instrumentational-Engineering-20131 AnswerThe approximate model obtained by retaining only one of the above poles, which is closest to the frequency response of the original transfer function at low frequency is GATE-Instrumentation-Engineering-20141 AnswerAn air–filled rectangular waveguide of internal dimensions a cm bcm a b has a cutoff frequency of 6 GHz for the dominant TE10 mode. -GATE EC 20151 AnswerA diode detector is used to detect an amplitude modulated wave of 60% modulation by using a condenser of capacity 250 pico farad in parallel with a load resistance 100 kilo ohm. Find the maximum modulated frequency which could be detected by it. - physics 20131 AnswerGive the following measurements Frequency of FP operations=25% Average CPI of other instructions=1.33 Average CPI of FP operations=4.0 Frequency of FPSQR=2% CPI of FPSQR = 20 Assume that the two design alternatives are to decrease the CPI of FPSQR to1 AnswerA sonometer wire of length 1.5 m is made of steel. The tension in it produce an elastic strain of 1%. What is the fundamental frequency of steel if density and elasticity of steel are 7.7 × 103 kg / m3 and 2.2 × 1011 N/m2 respectively ? - physics 20131 AnswerThe trigonometric Fourier series of an even function does not have the -gate-ece-20111 AnswerStandard air – filled rectangular waveguides of dimensions a = 2.29 cm and b= 1.02 cm are designed for radar applications. It is desired that these waveguides operate only in the dominatnt1 AnswerThe width of each of five continuous classes in a frequency distribution is 5 and the lower class limit of the lowest class is 10. What is the upper class limit of the highest class? CBSE class 9 Mathematics1 AnswerA mass-spring-dashpot system with mass m = 10 kg, spring constant k = 6250 N/m is excited by a harmonic excitation of 10 cos(25t) N. At the steady state, the vibration amplitude of the mass is 40 mm. The damping coefficient (c, in N.s/m) of the dashp1 Answer